UPVC profiles: window, door, and decorative ranges

Window and door profiles

Window and door profiles are chosen by the frame they must build, and the enquiry should describe that frame: the type of window or door, the opening it fits, and any existing section it must match or replace. Custom window-door profiles are mentioned on the company website, which suggests that non-standard frames can be discussed, but the scope of custom work is an enquiry question, not a published promise. The customization page on this site frames that discussion, and it asks the buyer to state the frame type, the quantity, and any drawing or sample that defines the section.

Decorative profiles are chosen by appearance, and the enquiry should describe where they will be seen and what they must match. A decorative section that trims a window, edges a panel, or finishes an interior feature is judged at close range, so a sample or a photograph of the intended use is more useful than a general description. The decorative profiles guide on this site sets out those questions, and a buyer who works through them will be able to describe the decorative need in terms the supplier can answer directly.

Profiles for new work and for replacement

Profile work falls into two kinds, and the enquiry differs between them. New work, for a new window, door, or feature, starts from the design: the opening, the frame type, and the appearance required, and the supplier can recommend a series or discuss a custom section from that design. Replacement work, for an existing frame, starts from the existing section: a drawing, a photograph with a scale reference, or a sample, together with the quantity and the reason for replacement. A buyer who states which kind of work is involved, and supplies the corresponding material, will receive a faster and more accurate answer than a buyer who asks about profiles in general.

Quantities also differ between new and replacement work. New work often involves many identical sections for a project, while replacement work often involves a few sections for a single frame, and the supplier discussion, including any custom or minimum quantity question, will differ accordingly. Stating the quantity and the kind of work together, with the frame description, gives the supplier the complete picture for either case, and it avoids a quotation that assumes the wrong kind of job.

Questions to settle in your enquiry

• Which profile type is needed: window, door, or decorative?
• Which series name applies, and what frame or feature is it for?
• Is a section drawing or sample needed before ordering?

In this range: UPVC Profiles